RB900SG QuickStart: Różnice pomiędzy wersjami
Znaczniki: Ręczne wycofanie zmian Wycofane |
|||
| (Nie pokazano 19 pośrednich wersji utworzonych przez tego samego użytkownika) | |||
| Linia 1: | Linia 1: | ||
{{Template: | {{Template: QuickStart | ||
| model = RB900SG | | model = RB900SG | ||
| type = | | type = modem | ||
| ant_marking = "ANT" | | ant_marking = "ANT" | ||
| power_adapter = 1 | | power_adapter = 1 | ||
| power_source = adapter | | power_source = adapter | ||
| variants = 1 | | variants = 1 | ||
| jumper = 1 | |||
| usb_conf = 1 | |||
| meter = 1 | |||
| mounting = 1 | |||
| wireless = 1 | | wireless = 1 | ||
}} | }} | ||
Aktualna wersja na dzień 14:00, 12 kwi 2024
This page contains instructions on how to get started with RB900SG modem and how to configure it.
Package contents
Complete package contains:
- RB900SG modem
- RJ45 cable
Please check additional accessories in RB900SG Accessories
Variants
List below shows typical configuration and different variants of the RB900SG modem.
The RB900SG modem variants and their description are listed in the table below.
| Model | Description |
|---|---|
| RB900SG-E5.X.X.2.X.X | LTE Cat. 4 modem |
It is possible to use SIM-CHIP solution. Example P/N of the modem with SIM-CHIP: RB900SG-E5.X.C.2.X.X – LTE Cat. 4 modem with SIM-CHIP. Last parameter in P/N depends on modem accessories. Please check available accessories in RB900SG Accessories
Presentation
Front
Back
Setting up the modem
Serial ports configuration
At the production stage, the device is set up with a RS232 serial interface (without the jumper inside). If there is a need to change the interface to RS485 please open the device housing and plug the jumper on the appropriate connector of the internal board (as in the picture below) and close the housing.
USB configuration
- Connect the USB cable to the computer. If you want to configure the modem with SIM card inside, please connect also the power adaptor.
- Configure the modem using the Smart Manager program. If you plug the jumper inside the modem (for RS485 interface), please set „485-4W” (full-duplex) or „485-2W” (half-duplex) in „Serial” -> „Serial type” in „Basic” menu tab, save the configuration and reboot the modem. The detailed configuration procedure is described in the Elproma Smart Manager User Manual document.
- If you can’t connect to the modem, follow these steps:
- check if the modem is connected to the computer via USB interface - check if the COM port number is correct
- Disconnect the USB cable after setting up the device.
Inserting SIM cards
- Push yellow button placed on the front panel and take SIM drawer(s) out.
- Place the SIM card in the holder as shown in the picture.
- Put the drawer into the modem.
Connection
- Connect GSM/LTE antenna to SMA connector marked as "ANT"
- Connect power adapter into power supply connector
* If you want to power the modem from the meter you MUST disconnect the power adapter. Then connect the modem with the meter using RJ45 cable (the modem will be powered directly from the meter).
Mounting the modem
To mount the modem inside the meter housing, please use one of the handles. The available handles are shown in the photos below.
The method of mounting the modem in the ITRON SL7000 housing is shown in the photo below.
