TFD-100 Safety Recommendations

Caution, refer to manual. Read all instructions in Manual before using this product.

This symbol means the following information is a note that gives you important information that may affect how you use the TFD-100

CE marking, attesting compliance to applicable European Directives

ATTENTION!
These are the important Safety Instructions that should be followed during installation and maintenance of the ELPROMA family product.
IMPORTANT NOTE.
This equipment contains hazardous AC and DC voltages. Do not handle any metallic part until the power has been disconnected. Do not assemble, disassemble set when the power is ON. Making wiring and touching cables is strongly prohibited when power is ON. Please refer to your RACK’19 safety instruction to learn more about connecting power to equipment. The TFD-protection system requires PE line to be connected into RACK’19 din rails.
Elproma safety advises:
1. Safety first! Never work alone under hazardous voltage conditions
2. High short circuit current trough conductive materials can cause unit burns
3. Check that the power cord(s), plug(s), and sockets are in good conditions
4. Always use qualified service personnel to install permanently wired equipment
5. Do not handle any metallic part before the main power has been disconnected
6. Take care your power lines and rack’19 frame is properly PE grounded
Depending on your device or the installed options some information is not valid for your device. The device satisfies the requirements of the following EU regulations: EMC-Directive, Low Voltage Directive, RoHS Directive and - if applicable - the Radio Equipment Directive.