RB900SG-ElpOS QuickStart: Różnice pomiędzy wersjami
Znacznik: Wycofane |
Znacznik: Ręczne wycofanie zmian |
||
| (Nie pokazano 12 pośrednich wersji utworzonych przez tego samego użytkownika) | |||
| Linia 1: | Linia 1: | ||
{{Template: | {{Template: QuickStart | ||
| model = RB900SG-ElpOS | | model = RB900SG-ElpOS | ||
| type = | | type = modem | ||
| ant_marking = "ANT" | | ant_marking = "ANT" | ||
| power_adapter = 1 | | power_adapter = 1 | ||
| Linia 8: | Linia 8: | ||
| jumper = 1 | | jumper = 1 | ||
| usb_conf_elpos = 1 | | usb_conf_elpos = 1 | ||
| wireless = 1 | | wireless = 1 | ||
}} | }} | ||
Aktualna wersja na dzień 15:24, 7 maj 2024
This page contains instructions on how to get started with RB900SG-ElpOS modem and how to configure it.
Package contents
Complete package contains:
- RB900SG-ElpOS modem
- RJ45 cable
Please check additional accessories in RB900SG-ElpOS Accessories
Variants
List below shows typical configuration and different variants of the RB900SG-ElpOS modem.
The RB900SG-ElpOS modem variants and their description are listed in the table below.
| Model | Description |
|---|---|
| RB900SG-E5.E.X.2.X.X | LTE Cat. 4 modem with ElpOS |
It is possible to use SIM-CHIP solution. Example P/N of the modem with SIM-CHIP: RB900SG-E5.E.C.2.X.X – LTE Cat. 4 modem with SIM-CHIP. Last parameter in P/N depends on modem accessories. Please check available accessories in RB900SG-ElpOS Accessories
Presentation
Front
Back
Setting up the modem
Serial ports configuration
At the production stage, the device is set up with a RS232 serial interface (without the jumper inside). If there is a need to change the interface to RS485 please open the device housing and plug the jumper on the appropriate connector of the internal board (as in the picture below) and close the housing.
USB configuration - ElpOS
- Connect the USB cable to the computer. If you want to configure the modem with SIM card inside, please connect also the power adaptor.
- Login to the web platform. The detailed configuration procedure is described in the RB900SG-ElpOS Web Platform page.
- If you can’t connect to the modem, follow these steps:
- check if the modem is connected to the computer via USB interface - check if your PC is in the same network as modem (default IP is 192.168.1.234)
- Disconnect the USB cable after setting up the device.
Inserting SIM cards
- Place the SIM card in the holder as shown in the picture.
Connection
- Connect GSM/LTE antenna to SMA connector marked as "ANT"
- Connect power adapter into power supply connector