NTS-pico3 Troubleshooting: Różnice pomiędzy wersjami
Z Elproma Wiki Knowledge Base
| (Nie pokazano 1 pośredniej wersji utworzonej przez tego samego użytkownika) | |||
| Linia 29: | Linia 29: | ||
==How to reset the device to factory default settings?== | ==How to reset the device to factory default settings?== | ||
Please use the "R" button as described in [[ | Please use the "R" button as described in [[NTS-pico3_Connectors|Connectors]] | ||
[[Category:NTS-pico3 User Manual]] | [[Category:NTS-pico3 User Manual]] | ||
Aktualna wersja na dzień 13:56, 2 lip 2024
To troubleshoot NTS-pico3 you need first to log into device console using serial cable or SSH.
How to check if PTP is working?
From NTS-pico3 console you can check if ptp process is running. If everything is fine, you shall get 1 in return:
If there is no ptp process you will get 0 (make sure, that you have enabled PTP in web panel):
How to check if NTS-pico3 sends PTP messages?
To check if NTS-pico3 is actually sending PTP IEEE1588 messages over your LAN network you use tcpdump utility and see if PTP frames are going out of device:
1) PTP L2 (Ethernet)
- To see only PTP (0x88F7) Ethernet packets:
2) PTP L4 (UDP)
- To capture PTP UDP transmission we need to dump tcp packets going to ports 319 and 320:
How to reset the device to factory default settings?
Please use the "R" button as described in Connectors