Szablon: QuickStart: Różnice pomiędzy wersjami
Z Elproma Wiki Knowledge Base
| Linia 220: | Linia 220: | ||
==Setting up the {{{type}}}== | ==Setting up the {{{type}}}== | ||
{{#ifeq: {{{jumper}}} | 1 | | |||
===Serial ports configuration=== | |||
At the production stage, the device is set up with a RS232 serial interface (without the jumper inside). If there is a need to change the interface to RS485 please open the device housing and plug the jumper on the appropriate connector of the internal board (as in the picture below) and close the housing. | |||
[[File:{{{model}}}_jumperrs485.png|400px|border|class=tlt-border]] | |||
[[File:{{{model}}}_jumperrs232.png|400px|border|class=tlt-border]] | |||
}} | |||
{{#ifeq: {{{wireless}}} | 1 | | {{#ifeq: {{{wireless}}} | 1 | | ||
===Inserting SIM cards=== | ===Inserting SIM cards=== | ||
Wersja z 14:46, 22 maj 2023
This page contains instructions on how to get started with {{{model}}} {{{type}}} and how to configure it.
Package contents
Complete package contains:
- {{{model}}} {{{type}}}
[[File:{{{model}}}_package.png|800px|border|class=tlt-border]]
Presentation
Front
[[File:{{{model}}}_front.png|400px|border|class=tlt-border]]
Back
[[File:{{{model}}}_back.png|400px|border|class=tlt-border]]
Setting up the {{{type}}}
[[Category:{{{model}}}]]