Szablon: QuickStart: Różnice pomiędzy wersjami
Z Elproma Wiki Knowledge Base
Znacznik: Ręczne wycofanie zmian |
|||
| Linia 292: | Linia 292: | ||
At the production stage, the device is set up with a RS232 serial interface (without the jumper inside). If there is a need to change the interface to RS485 please open the device housing and plug the jumper on the appropriate connector of the internal board (as in the picture below) and close the housing. | At the production stage, the device is set up with a RS232 serial interface (without the jumper inside). If there is a need to change the interface to RS485 please open the device housing and plug the jumper on the appropriate connector of the internal board (as in the picture below) and close the housing. | ||
[[File: | [[File:{{{model}}}_jumperrs485.png|400px|frameless|class=tlt-border]] | ||
[[File: | [[File:{{{model}}}_jumperrs232.png|400px|frameless|class=tlt-border]] | ||
}} | }} | ||
{{#ifeq: {{{usb_conf}}} | 1 | | {{#ifeq: {{{usb_conf}}} | 1 | | ||
Wersja z 14:02, 7 maj 2024
This page contains instructions on how to get started with {{{model}}} {{{type}}} and how to configure it.
Package contents
Complete package contains:
- {{{model}}} {{{type}}}
[[File:{{{model}}}_package.png|500px|frameless|class=tlt-border]]
Presentation
Front
[[File:{{{model}}}_front.png|400px|frameless|class=tlt-border]]
Back
[[File:{{{model}}}_back.png|400px|frameless|class=tlt-border]]
Setting up the {{{type}}}
[[Category:{{{model}}}]]