RB900SG QuickStart

This page contains instructions on how to get started with RB900SG terminal and how to configure it.

Package contents

Complete package contains:

• RB900SG terminal
• RJ45 cable

Please check additional accessories in RB900SG Accessories

Variants

List below shows typical configuration and different variants of the RB900SG terminal.

The RB900SG terminal variants and their description are listed in the table below.

Model	Description
RB900SG-E5.X.X.2.X.X	LTE Cat. 4 terminal

It is possible to use SIM-CHIP solution. Example P/N of the modem with SIM-CHIP: RB900SG-E5.X.C.2.X.X – LTE Cat. 4 modem with SIM-CHIP. Last parameter in P/N depends on modem accessories. Please check available accessories in RB900SG Accessories

Presentation

Front

Back

Setting up the terminal

Serial ports configuration

At the production stage, the device is set up with a RS232 serial interface (without the jumper inside). If there is a need to change the interface to RS485 please open the device housing and plug the jumper on the appropriate connector of the internal board (as in the picture below) and close the housing.

Inserting SIM cards

• Push yellow button placed on the front panel and take SIM drawer(s) out.

• Place the SIM card in the holder as shown in the picture.

• Put the drawer into the terminal.

Connection

• Connect GSM/LTE antenna to SMA connector marked as "ANT"
• Connect power adapter into power supply connector