Szablon: Textcommands
This page contains the list of text commands supported by {{{model}}} {{{type}}} and its description.
All below commands are available from 3.0.x modem firmware version. They can be send over USB, SMS or Teleorigin Manager.
Special characters: <EXT> - End of Text 0x03 character <CR> - Carriege Return 0x0D character <LF> - Line Feed 0x0A character
NOTE: <CR><LF> characters can be omitted when the command is sent via SMS and Teleorigin Manager („Console” tab).
Device commands
| RB900SG Commands | |
|---|---|
| RB900SG GET FW VERSION<CR><LF> | Downloads the firmware version number of the microcontroller |
| Response | x.x.x<CR><LF>
where x – version number |
| Response example | 3.0.0<CR><LF> |
| RB900SG GET IP<CR><LF> | Retrieves the IP address of the device |
| Response | x.x.x.x<CR><LF> |
| Response example | 10.43.210.2<CR><LF> |
| RB900SG GET RTCTIME<CR><LF> | Gets device time in Unix time or unless the clock is out of sync then rtc time is equal uptime |
| Response | xxxx<CR><LF> |
| Response example | 868<CR><LF> |
| RB900SG GET UPTIME<CR><LF> | Gets the number of seconds since the device startup |
| Response | xxxx<CR><LF> |
| Response example | 868<CR><LF> |
| RB900SG RESET<CR><LF> | Resets the device |
| Response | - |
| Response example | - |
| RB900SG TIME<CR><LF> | Returns the current time in human-readable version |
| Response | Time: xxxxxxxxxx, mm-dd-yyyy hh:mm:ss<CR><LF> |
| Response example | Time: 1619618224, 11-30-2021 13:57:04 <LF><CR><LF> |
| RB900SG LOG PRINT<CR><LF> | Sends all entries from the event log |
| Response | ------------------------------------------------------
Sep 12:30:05 - x.x.x<CR><LF> Sep 12:30:08 - SIM ready<CR><LF> Sep 12:30:09 - Cfg port opened<CR><LF> Sep 12:30:11 - PDP activated<CR><LF> |
| Response example | ------------------------------------------------------
Sep 12:30:05 - x.x.x<CR><LF> Sep 12:30:08 - SIM ready<CR><LF> Sep 12:30:09 - Cfg port opened<CR><LF> Sep 12:30:11 - PDP activated<CR><LF> Sep 12:30:12 - IP: 46.77.88.87 Sep 12:30:14 - Sync to NTP |
| RB900SG LOG FORMAT<CR><LF> | Removes all entries from the event log |
| Response | OK<CR><LF> |
| Response example | As above |
| RB900SG GET HW VERSION<CR><LF> | Downloads the hardware version number of the device |
| Response | x.x.x<CR><LF>
where x – version number |
| Response example | 2.3.1<CR><LF> |
| RB900SG BATTERY VOLTAGE<CR><LF> | Downloads battery voltage in volts |
| Response | X.XX<CR><LF> |
| Response example | 4.08<CR><LF> |
| RB900SG GET TEMPERATURE<CR><LF> | Downloads temperature of the device |
| Response | XX.X *C<CR><LF> |
| Response example | 30.5 *C<CR><LF> |