RBVND-Lite QuickStart
Z Elproma Wiki Knowledge Base
This page contains instructions on how to get started with RBVND-Lite modem and how to configure it.
Package contents
Complete package contains:
- RBVND-Lite modem
- Antenna (SMA connector)
- 20-pin cable
- 14-pin cable
Variants
List below shows typical configuration and different variants of the RBVND-Lite modem.
| Function | RBVND-Lite NB |
|---|---|
| Industry Standards: MDB/EXE / DEX/DDCMP (EVA DTS) | ○ / ● |
| Audits from Printer, Modem, etc. | ● |
| FTL over MDB support | ○ |
| Mobile payments | ○ |
| Generating audits for non EVA-DTS machines | ● |
| Open API | ● |
| LTE Cat. M1, NB1 & 2G | ● |
| eSIM | ○ |
| RFID | ○ |
| SD card | ○ |
| External flash | 4 MB |
| Peripheral Port: USB (Host/Device), Ethernet | ○ |
| RS232 interface | x 1 |
| TTL level UART (only one 232 RS is available if we use it) | ○ |
| GPIO (counter/pulse/analog/sensors/switches) | ○ |
| 2 x MDB/EXE - capture and analyze messages from all MDB peripherals connected to the same line | ○ |
| MDB as master | ○ |
| Accelerometer / Restock button / Buzzer notification / Universal button | ○ / ● / ○ / ○ |
| Remote software update (OTA) | ● |
| Battery - for power down alert | ○ |
Presentation
Front
Back
Setting up the modem
Inserting SIM cards
- Open the case, slide out the PCB and turn it over.
- Place the SIM card in the holder as shown in the picture.
- Put the board back to the case and close it.
Connection
- Connect GSM/LTE antenna to SMA connector marked as "ANT"
- Connect power supply cable into power supply connector